CineStill D9 ”Creative Slide” Dynamic -diafilminkehite 1l

Kuvaus

Käyttöohje (eng)

Safety Data Sheet

D9 “DynamicChrome” Warm-Tone Dynamic 1st Developer.
Renders approximately 9+ stops of usable dynamic-range*! Conventional E-6 processing renders approximately 6 stops of usable dynamic-range*. The world’s most flexible 1st developer for slide film, giving the photographer the choice between warm-tone slides with slightly extended highlights and shadows detail (1+1 Dilution), or even more expanded dynamic range (1+2 Dilution) for high contrast scenes with a subtle warming effect achieved by simply changing the chemistry dilution of your working solution!
1000ml stock solution makes 2000ml of single-use working solution (1+1 dilution) to develop 8-16 rolls or 100ft of Slide Film.
1+1 Dilution ~ 9min. 40°C**
Extended exposure latitude while maintaining vibrant color-contrast and rich warm-tones with preserved highlight and shadow detail (optimized for scanning) for a more cinematic look. High-dynamic-range for warm-tone slides in daylight, shade or with electronic flash.

Cr6 “Color&Reversal” Color Developer & Reversal Bath.
The reversal step occurs during color development in a Color&Reversal bath,
1000ml Reusable Solution Reverses 16+ Rolls of Developed Slide Film.
Stock > 6min @ 27-40°C**

Bf6 “Bleaches&Fixer” Pre-Bleach & Blix Bath.
The bleach and conditioner steps are combined with the fixing step in a Bleaches&Fixer bath.
1000ml Reusable Solution Clears 24+ Rolls of Reversal Film.
Stock > 6-10min @ 23-40°C**

* ”Usable dynamic-range” is the amount of full stops of exposure value that renders acceptable detail and color. “Total dynamic-range” however, is the maximum range containing tonal separation rendering any detail, and is often twice the usable dynamic-range. The usable dynamic-range of conventional slide film is between 6-8 stops (total 14-16 stops). Color negative is between 9-13 stops (total 16-21 stops). Digital sensors are mostly between 7-10 stops (total 12-15 stops).

** Maintaining temperature is not essential beyond pouring in a 1st developer. When a temperature control bath is not available, simply preheat the 1st Developer +1ºC warmer, and the other baths will automatically process-to-completion as they cool down. Only the 1st developer is time and temperature critical because it controls contrast and color.